FAG Split plummer block housings SD31
series are made of flake graphite cast iron,We use suffix L to indicate,this FAG housing for spherical roller bearings 231...K with tapered bore and adapter sleeve,these housings are intended for bearing arrangements subjected to heavy loads, spherical roller bearings are located
on the shaft by means of adapter sleeves, from SD3144 ,the housings are supplied as a locating bearing design or non-locating bearing design, smaller housings initially give non-locating bearing arrangements, locating bearing arrangements can be achieved by the insertion of locating rings on both sides of the spherical roller bearings, locating rings must be ordered separately.
FAG split plummer block housings are intended for grease lubrication and can be relubricated via a lubrication nipple. for the holes required for oil lubrications,the upper and lower section of the housings have cast-on bosses. the seal is a three-section labyrinth, labyrinth seals allow shaft misalignment of up to 0.25 degree in both directions, housings closed on one side are supplied with a steel cover. the ring bolts in the upper section of the housing must not be loaded to a value greater than the mass of the housing including the bearing. the housing material is flake graphite cast iron, load carrying capacity of split plummer block housings.
Designation of FAG Split plummer block housings SD31 series
XRB as the experienced China bearing manufacturer
& factory & exporter & supplier ,it can supply Original FAG Split plummer block housings SD31 series,Our large quantity FAG Split plummer block housings SD31 series Stock can meet your need with lowest price and fast delivery.
We accepted DHL,FEDEX,TNT express for small order and samples order,also the transportation By AIR or By Sea,by Train are all avaiable.we are sure we can ship our FAG Split plummer block housings SD31 series to your office at the first time. More technical details,please contact with :