FAG Split plummer block housings SNS

Split plummer block housings are made of cast iron and cast steel,FAG Split plummer block housings SNS series represent a completely new generation of large size housings,through the systematic further development of the proven FAG SNS Split plummer block housing,FAG offer cost-effectiveness for machinery and plant and even greater efficiency,the unique housing design gives an increase in the life of the spherical roller bearings in the housing of up to 50%,this is achieved through optimised load distribution in the bearing that occurs due to the interaction of the bearing and housing geometry under load.

 

FAG Split plummer block housing SNS series and the associated bearings form bearing arrangements units that can be matched,through the specific selection of seal design,lubrication type and bearing mounting,to wide range of requirements,the housings are specifically designed for the fitting of spherical roller bearing,sealed spherical roller bearings.the housings are designed in accordance with a modular concept,each housing can be fitted with spherical roller bearings of various diameter and width series if they have the correct outside diameter for the housing,depending on their design,the spherical roller bearing can be locating either directly on the shaft or by means of an adapter sleeve,this gives different shaft diamter for the same bearing size,the spacings between the shaft and housing body are compensated by means of appropriately matched seals.FAG Split plummer block housing SNS series can be replace SKF Split plummer block housings SNL Series,these housing are suitable for fitting with spherical roller bearings with tapered or cylindrical bore, unsplit spherical roller bearing with an adapter sleeve can be replaced by split spherical roller bearings,this gives a considerable reduction in the work associated with bearing replacement in numerous applications.